Install Videos

Notice how many part come with our 7 piece kit. That is right, it comes with about 7 parts to install. Our hydrogen kit has so 

few parts and is so simple to install it can be done with a pair of scissors, a 10 millimetre socket wrench and a screwdriver. 

While it is better to have a pair of cutting pliers or snips it is that easy if you are in a pinch.

How to they install?

Through the natural motor vacuum of the car. As we put a lot of R&D into this hydrogen kit to make it state of the art, it is 

applied to the motor vacuum of the car. The natural motor vacuum of the vehicle sucks the gas from the canister, right where

 the gas is made, to deliver this to the motor in a smooth and even fashion.

All that is required is:

You remove a motor vacuum hose from the throttle body of the motor.

Cut a 3 or 4” piece of hose we give you.

Insert it onto the throttle body of the motor.

Attach the T fitting.

Attach the motor vacuum hose to the T fitting.

Install mounting bracket.

Insert generator, zip tie in.

Add controller box; attach electrical to battery.

Run LED display into cabin.

Plug LED display and generator into controller box.

It takes about 45 minutes on a average car.

As the generator is round, and approximately 6 inches across, 14 inches deep it fits in tight places. It can also be installed 

in the trunk or cabin of the car if you cannot find a place under the hood.